Thursday, October 17, 2013

pachamama project: steel feathers


my next big project in the metal department is a large wall piece dedicated
 to pachamama (mother earth in quechua). I have started with some loose sketches for design 
guidelines and material choices and have chosen to start with 18g steel feathers that will fall from her hair. 


I began with a plasma torch to cut the shapes out, then sandblasted them for cleaning and a matte
 look. I then used a dremel to indicate where I wanted to braze (melting bronze rod onto the surface of the steel). After brazing, the rest of the steel was blacked from the torch. To remove the fire scale and clean the metal I used the sand blaster again, however it is necessary to tape over the bronze 
beforehand to protect it- the sand blaster will not remove the bronze, but it will dull it the same as any other surface.



Once the tape is removed, voilà! Now it's time to add the details with the dremel. I used a 
diamond bit (which you're definitely not suppose to use), which sort of worked out but wore it
 down..I'm not entirely sure what would be the best. Keep in mind that unprotected sand
 blasted metal picks up finger prints very easily, so keep your fingers on the edges while
 working until a protective lacquer has been applied.


To finish the pieces, I chose to do a heat patina using a portable propane torch for a blue 
purple coloring. The lame thing about heat patina's is they are pretty much impossible to maintain. 
They always look so bright when created, but darken and dull fairly quickly. Not
 to mention they need some sort of lacquer finish to protect them- which in my experience, darken 
and dulls them immediately.



my favorite result: loved the way using excess bronze over already-cut areas filled it in
 completely keeping the texture intense but solid and smooth (pictured above)
what I forgot: use a wire brush after the brazing to remove any lingering flux and fire scale
(it will give the bronze a cleaner look)
for the future: maaaaybe try a 0 or 00 torch tip for more control? (used a 1)

torches, sparks, and dirty hands. yup it's a thursday!
h.

1 comment:

  1. Excited for you! Very creative and beautiful. Can't wait until you work on the face.

    ReplyDelete